Replies to This Discussion

Permalink Reply by DaveyWaveyBunsenBurner on November 27, 2011 at 1:29pm

Hi,

The receiver isnt in high speed digital servo mode is it?

Some receivers have a mode where the update eery 7ms instead of 14ms. This would potentially cause problems.

Permalink Reply by f8 on November 27, 2011 at 3:11pm

Can you try connecting every other channel( only odd channels)?

It can be the same problem as I have:

http://diydrones.com/forum/topics/rx-7-synth-reciever

Permalink Reply by Alfred Riopel on November 27, 2011 at 4:18pm

Davey, There is no distinction in the 12X or the matching 12ch receiver. No facility to change it to accomodate digital vs analog servos. At least none I have found in the manual.

 

F8, You may be correct there. They had to make room somewhere for the extra channels. Overlapping may have been the solution.

 

Permalink Reply by ahmed hakeem on November 27, 2011 at 11:33pm

did u mean its not CONNECT  ???

u mean u have arducopter and want to fly but cant connect ?

or u r talking about SERVOs ??

Permalink Reply by Alfred Riopel on November 28, 2011 at 6:39am

ahmed,  I am building/rebuilding a quad with the arduMega 2560. The ardumega deos not see/recognise the output from the JR 12ch receiver. It will not pass the radio setup in the Mission planner or CLI.

I used a servo connected directly to the receiver to test that the reciever was actually functioning, but only for test.