Z axis accel implementation

I read a post somewhere about activating the Z-axis accel. Can't find it now.

 

I would like to activate the Z-accel to stabilize the altitude at hover. Want to be able to demonstrate the push the copter down and it pops back up to where it was.

 

Could someone point me to the information needed to active and tune this sensor?

Thanks...

Views: 76

Replies to This Discussion


JDronesPermalink Reply by Jani Hirvinen on November 28, 2011 at 8:28pm

Alfred, it is on it's alpha stage and not reliable yet. You can only activate it during compile time but as said. It's not ready yet and does not work properly. I would suggest to wait until work is a bit further with it.

Permalink Reply by Alfred Riopel on November 28, 2011 at 8:59pm

Jani,  Thanks for the update. I will watching and waiting.

RSS

Social Networking

Top Content 

1 ArduPlane 2.73 released

ArduPlane 2.73 released
2 How to analyze a crash?

How to analyze a crash?
3 ArduVTOL

ArduVTOL
4 NEVER connect a Capacitor backup or voltage protector on APM board

NEVER connect a Capacitor backup or voltage protector on APM board
5 HD video for UAV's

HD video for UAV's
6 APM Copter 2.9.1.b has been released

APM Copter 2.9.1.b has been released
7 DIYDrones Chat Feature Info

DIYDrones Chat Feature Info
8 Arducopter Question

Arducopter Question
9 Arducopter 3Dr or Phantom

Arducopter 3Dr or Phantom
10 ArduVTOL - Wingcopter - Flight Report Nr.1

ArduVTOL - Wingcopter - Flight Report Nr.1

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here. 

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service