Ardurover with "old" ardupilot legacy

Hi all!!!!! Can anyone tell me and help me if it's possible to use this version of ardupilot, legacy, for test it on the ground on an rc car? I have one of this and i never be able to really test it.... i'm so sad!!!!

0 members like this

Replies to This Discussion

AdminPermalink Reply by Thomas J Coyle III on December 19, 2012 at 2:27pm

@luca,

The ArduPilot legacy uses an Atmel 328 that does not have sufficient memory even for the ArduRover "Lite" code which requires an Atmel 1280. You will need either an APM1 (1280) or an APM1.4 (2560) to test the ArduRover code. Sorry.

Regards,

TCIII

Permalink Reply by Stephen James Gardiner, CPS on January 1, 2013 at 11:18am

I'm trying it with the 2.7.1 code to a dual motor systems. I'll let ya know how it goes. I'm mostly using it for the Auto pilot functionality. I have the outputs going into an Arduino Uno to translate to what I need for motor control etc.

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Getting ready for Arducopter 3.0
10	Help Tuning Arduplane 2.73 With A Large Slow Airframe

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.