I am little confused about two GPS setup.
1. My main GPS is a "Here GNSS" with 8 pin connector which will go into GPS-1 Port.
2. Now the 2nd GPS port on Pixhawk 2 is 7 PIN connector!
Do I need a specialized GPS for the 2nd GPS? or I can order a "Here G
Read more…Hi I am starting to build new octocopter based on Pixhawk 2.1. I have few years of experience in building and flying custom Mikrokopter copters. All advices are welcome !
What are the biggest differences between this autopilots ? I am sure that same
Hello All,
Had a pretty rough go of it today. We were flying at 8-10 feet today, doing a little tuning in stabilize mode. Craft was looking more stable than it ever has. Entered forward flight, came to a stop in a hover at about 8 feet. Suddenly c
Read more…HI Guys
Where would the best place be to get an external LED for FC status ?
Thanks
Read more…Occasionally it seems that even with the excellent cables provided with the Pixhawk 2.1 - you'll need to make a special cable.
9 of the connectors on the top of the Pixhawk 2.1 are JST GH connectors
I didn't see specific part numbers or sourcing for th
Read more…Occasionally it seems that even with the excellent cables provided with the Pixhawk 2.1 - you'll need to make a special cable.
9 of the connectors on the top of the Pixhawk 2.1 are JST GH connectors
I didn't see specific part numbers or sourcing for th
Read more…Ken McNamara sent a message inquiring about what GPS to use with your new Pixhawk 2.1: I believe this is a great subject for a new discussion. Right now, I believe there is only the "HERE" GPS that is available as a "plug-and-play" solution for the P
Read more…I have been trying to get my digital airspeed sensor to work and while doing some research I came across this post that claims that the "I2C2" port on the PX2.1 does not work:
http://discuss.ardupilot.org/t/pixhawk-2-1-with-maxbotic-i2cxl-maxsonar-ez-
Read more…This is the first plane I will attempt to automate with my new PH2.1: She's called the Junco3 , has a wingspan of 48 inches, weighs 2600Gr. (5 lbs 12 oz) and is powered by two 45 Amp setups in 3s (35-30 1400Kv with 10x4.7 props). Her cubic wingload i
Read more…This is how my Pixhawk2 arrived in the mail
It is beautifully packaged in felt covered foam; it is very well protected and gorgeous to look at.
The GPS unit is much larger than I expected
Under the main display foam is all the accessories
Note the nice 3
Read more…