Share 'ESC problems- Calibration of ESC for Plane with PX4'
I just ran into some troubles trying to get my fixed-wing aircraft to work again.
After I had a failure of my rudder during flight I tried to figure out why and then none of my servos responded anymore (lukily on groud allready).
I'm using a PX4 with the Ardupilot Plane-firmware 3.7.0.
I have a single motor with a MULTIPLEX BL-20 SD-L (ESC).
The Problem I am having is as follows:
You can share this discussion in two ways…
Share this link:
Send it with your computer's email program: Email this