coaxial-v9-800g

added simple 2.5mm RCF foam strip to act as prop shroud and duct. RCF is an extruded polystyrene that is similar to Depron but higher density. Initial tests show that the addition of the duct significantly enhances stability of the flyer

0 members like this

View Full Size

Tags: baby, coaxial, hiller, rotor

Comment by Barron on April 3, 2008 at 8:33am: Very Nice !

Comment by Patrick Hammer on July 21, 2011 at 8:01am: Where did you get your main motor?

Looks very cool!

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
2	APM Copter 2.9.1.b has been released
3	APM Project vs DJI NAZA and WOOKONG
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	Misadventures in power electronics
6	MAAT final version is being tested
7	10k autonomous flight - telemetry guided flight, and other APM tests!
8	Drone shot down by police
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	"Distributed Flight Array"

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.