Photos

Comments

• 

  Martin Bellomo June 4, 2014 at 6:44pm

  Hi paul. I follow your progress on this airframe... I like it very much, i wish to build one soon.
  Do you consider to send me the files for laser cut ?
  Thanks.
• 

  Paul Marsh June 4, 2014 at 4:19am

  Hi Martin,

  Thanks for your note.  I can see where a small forward angle would help--thanks for the tip.

  This particular strut is made by Robart.

  Thanks again,
  Paul
• 

  Martin Bellomo June 3, 2014 at 6:01pm

  I like very much this landing gear (it is a DUBRO landing gear right?) however is not hard enough to absorb some impacts, you will need to give some angle to let the spring work. If you put it vertical, then you will find that the spring is not working right.