"sent paypal "

"my paypal address is atktoolco@hotmail.com send the invoice please. thanks Al"

"can you ship via us postal service ? How much for all 4 to zip 96931? I'll buy them. thanks Al"

"I need 3 of these . How much each? Let me know Thanks   Alan"

"I have a brand new apm1 for sale $95.00 send me an email at atktoolco@hotmail.com Alan"

"You can count the number of pins ..."

"http://code.google.com/p/ardupilot-mega/wiki/RC"

"Yea, not getting gps lock. does it matter where the gps antenna is plugged? there are two ports on each board ( same ) thanks Alan"

"I have a Jakub gimbal arriving in the mail today and I have 3 flight modes setup as well. I will try this out this weekend and see if the problem can be reproduced. If it can there might be a bug."

"you should connect your apm via usb and wait to get gpslock "

"You can get previous versions of ArduCopter from here. http://code.google.com/p/arducopter/downloads/list They might have to be compiled and/or uploaded through the Arduino IDE instead of the Mission Planner. If someone knows of a way to do it…"

"I am using the apm 1, 2650 I have the tilt on channel 5 and it works, I have the roll on 6 output but all it does is jerk the gimbal a bit to the side then lock. So I figure the output must be not channeled to the gyro's. As I stated earlier, I…"

"make sure your esc's have only one of the red wires attached to the board. All others must be cut to stop cross voltage.  Meaning , only one of the esc's will have the red wire actually plugged in.   I would do a esc calibration…"

"Wich APM are you running.  My camera tilt is on channel 5 but hooked up to A10 and A11 with a APM2.   have you enabled the following in Mission planner?   http://code.google.com/p/arducopter/wiki/AC2_Camera"