"I had the similar issue before and found out that after the calibration process,I need to flip the manual/auto switch(Channel 5) 5 times within a second for resetting the AP. After that the FMA sensor will behave as expected to control the rudder…"

"Chris:After I have calibrated the ArduPilot 2.0 with nose point to ground,it found out that the rudder has effect on the orientation of the plane but elevator has mininal movement when testing on ground.Is it normal when on ground test ?"

"The above Manual mode throttle not functioning after reverted from Auto mode problem is disappeared after I replaced the receiver from Futaba PCM to a normal PPM receiver."

"Sometimes when revert from Auto to Manual mode,the throttle will not be functioning not until lowering the stick all the way down then up again."

"I am having the similar problem (replaced ESC by a servo and confirmed Ardupilot not controlling the throttle).Sometimes when flip CH5 back to manual control,throttle not functioning not until lower the stick to minimum and go back to to…"

"This is my first time to turn off the default "fuse" and upload hex files to Attiny45 & ATmega168 ,I also came across the "error:test3 " problem before .But at the end,I found out that it was due to incorrect process when I…"

"I have just received the board today and the date of shipment is 11th Feb 2009,but it looks like that the Attiny firmware problem still exists with the new stock.Red LED steady "ON",blue and yellow LEDs are flashing with pattern,but MUX…"

"Can't we modify the code? Instead of using pinout 6 & 7 output 2 single servo pulse for controlling 2 servos,we use pinout 6 or 7 ONLY to send out a series of 8 channel pulse train(channel 7 & 8 for camera pan & tilt controls).then…"

"I finally made it and it was due to I have forgotten to add all .pde files to Arduino software before compiling."

"I am using ArduPilot Beta 1.0.2 Dec/28/2008,is it the latest update ?"

"When I tried to compile the Ardupilot.pde(17 Jan 2009 version) by Arduino(rev .13) ,it just half way thru than came up with an error message of "'Init_servo' was not declared in this scope In function 'void loop()':"…"