Attila
  • Male
  • United States
Share

Attila's Groups

Attila's Discussions

Need advice for PDB selection. Y6 to X8 conversion.

Started this discussion. Last reply by John Kleiber Mar 7, 2015. 3 Replies

I have a 3Drobotics Y6 with pixhawk. I am turning my Y6 into X8. My problem is that i am not sure what PDB to use. On 3Dr website i cant buy the Octa PDB that comes with the X8.I could use two 3DR…Continue

Tags: distribution, board, pixhawk, power, ESC

Need advice for Heavy lift multi rotor design

Started this discussion. Last reply by Crady von Pawlak Jun 21, 2014. 1 Reply

I have couple drones but now i am planing to build a heavy lift multi rotor.Looking for advice what to use, number of motors, types of motors, blades, battery. Trying to figure out the optimal power/…Continue

Tags: battery, design, props, motor, lift

Fatshark headtracking menu settings help needed

Started this discussion. Last reply by Hugh Dinwiddie Oct 8, 2015. 5 Replies

I have a pair of Fatshark Attitude v2 goggles with Trinity Head tracking. I set up my camera gimbal and it works fine on the default ch5/6. I am getting conflict on ch5 so i would like to set my…Continue

Tags: settings, help, menu, fatshark, head

Flipping Brushless gimbal controller 90 degrees

Started this discussion. Last reply by Attila May 14, 2014. 2 Replies

I have a 2 axis brushless gimbal controller that i wast to use on a gimbal setup to control and stabilise Yaw and Pitch instead of Pitch and Roll. Any ideas how to do that?Also is there any controll…Continue

Tags: stabilise, pitch, yaw, controller, RX

 

Attila's Page

Profile Information

Please tell us a bit about your UAV interest
3DR y6
Hometown:
LA

Attila's Blog

Flyboard® Air Test

Posted on April 19, 2016 at 9:56pm 10 Comments

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service