"Sorry, I didn't intend for you to change the firmware, just set the destination addresses as in the example.  Unfortunately, my computer had a disk hiccup, and I can't run or uninstall/install X-CTU at the moment or I would post…"

"Please take a look at this link.  Pay attention to the "Destination Address" section.  You need to set the destination address on both Xbees to point to the other Xbee.  Not just the PAN ID. "

"Rana, I did watch the entire video, and the only configuration that you perform is changing the baud rate.  As I said in my previous post, you need to set the PAN IDs to the same value (I'm not sure if 0 is valid), and set the destination…"

"I suspect you have the XBees miss-configured.  I use these extensively for telemetry (including right this moment), andI don't have any problems if they're configured correctly.  They can be difficult to configure.  Most…"

"Hare you seen the OpenPilot ESC?"