Chris
  • Male
  • Franklin Park, NJ
  • United States
Share Twitter
  • Blog Posts
  • Discussions (33)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Chris's Friends

  • Prasant

Chris's Discussions

Video of my first real crash (minor damage)

Started May 26, 2012 0 Replies

broken motor wire on front left engine, luckily it happened low to the ground so the only chewed up the props a bit.was about 100ft agl about 30 seconds before the video starts...…Continue

Tags: quad, crash

First flights with arducopter controls (Gaui 330x extended frame)

Started this discussion. Last reply by Chris Aug 29, 2012. 8 Replies

had my first flights with a APM in a gaui 330x frame yesterday.used 2.0.40 for initial flights.  stabilize mode was right on but in loiter had major altitude changes.I have upgraded to 2.0.47 and…Continue

 

Chris's Page

Latest Activity

Chris replied to marc.kulhavy's discussion Worst Crash ever, Log analysis needed!
"good job clearing the crowd..  I know alot of people that would have been fighting to save the aircraft first without worrying about were it was. some advice.  learn to fly in acro mode...  if an accelerometer goes out or the…"
Sep 5, 2012
Chris replied to Chris's discussion First flights with arducopter controls (Gaui 330x extended frame)
"I am picking up a "quadrone" from david over at rcexplorer.se   basically a homebuilt kit that he is selling a few of.   http://www.rcexplorer.se/files/72b8c15805ea8f1121a01debfa2f25bd-348.html "
Aug 29, 2012
Ben Thomas replied to Chris's discussion First flights with arducopter controls (Gaui 330x extended frame)
"Fair enough. Thanks for your help.  By the way, what are you upgrading to? I am also looking at upgrading for the same reasons. The Gaui has been a great first quad but I'm wanting to do FPV and some aerial photography with a dslr etc.…"
Aug 29, 2012
Chris replied to Chris's discussion First flights with arducopter controls (Gaui 330x extended frame)
"I'm still around.   I plugged all the ESCs into the APM and it works fine. I have not been active lately because I am waiting for my new frame to show up... the gaui frame can not handle the weight of the camera and the FPV setup and the…"
Aug 29, 2012
Ben Thomas replied to Chris's discussion First flights with arducopter controls (Gaui 330x extended frame)
"Hi Chris, Hopefully you're still around.  Can you please tell me whether you plugged all your ESC leads straight into the APM or did you have to go via a power distribution board? Cheers."
Aug 29, 2012
Chris commented on estebanflyer's blog post How Not to Work on your Quad
Jul 5, 2012
Chris replied to Gerrit Jan Baarda's discussion Strange flip during flight
"just got to fly with 2.5.3 and the problem is gone.  full throttle no roll. gonna test some more this weekend when I get a chance. will try upgrading to 2.5.5 and see if it comes back "
Jun 6, 2012
Chris commented on ernani reis's blog post Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary
" Sandro Benigno :    got the image from monty python in  my head.   "Message for you, Sir""
Jun 2, 2012
Chris replied to Brad Smith's discussion What do you think the APM should do on fail safe
"My opinion would be on initial failsafe, enter loiter mode for a predetermined time...  after a delay ( say 30sec while it waits for a signal) enter RTL.  That way in case of a failure it will basically stop and wait to see if you can…"
Jun 2, 2012
Chris replied to James's discussion LEDs (big, serious LEDs) brightness control
"VERY simple.....   Brushed motor speed control. 12V input.  PWM output. saw it on an issue of "flitetest" on youtube http://www.youtube.com/watch?v=cdEHGw2UeYw&feature=plcp "
Jun 2, 2012
Chris replied to Gerrit Jan Baarda's discussion Strange flip during flight
"I have had this happen to me too...  I was not even at full throttle but at "fast climb" and I would get a hard roll over. gonna see if I downgrade and try it see if that clears anything up."
Jun 1, 2012
Chris posted a discussion

Video of my first real crash (minor damage)

broken motor wire on front left engine, luckily it happened low to the ground so the only chewed up the props a bit.was about 100ft agl about 30 seconds before the video starts...http://youtu.be/m_yCpUzDUxESee More
May 26, 2012
Chris commented on trappy's blog post UAVs and Wingsuit Basejumpers
"again..  video perfection "
Apr 15, 2012
Chris replied to bergsprekken's discussion best mode for getting up there and safely down
" you have got to post some video of this"
Mar 21, 2012
Chris replied to bergsprekken's discussion best mode for getting up there and safely down
"when I do a fast decent I pitch the quad full forward and reduce power till it starts to buffet around.. then increase throttle slightly till flight gets stable...  then I fly a downward spiral till I get to the altitude I wish. the other…"
Mar 21, 2012
Chris replied to Ruwan's discussion Share your drone info thread
"yeah, 8 x4.5 or so. the frame has some pros and cons..  the pro being that in minor crashes it pops apart rather then breaking, but that makes the frame rather flexible... "
Feb 6, 2012

Profile Information

About Me:
In RC for about 10 years. just got into quads got my ardupilot on 10/6/11
Tell us a bit about your UAV interest
Want to start aerial photography

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Social Networking

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service