Daniel
  • Male
  • Melbourne VIC
  • Australia
Share Twitter
  • Blog Posts
  • Discussions (9)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Daniel's Friends

  • Phil P

Daniel's Discussions

Strange motor behaviour

Started this discussion. Last reply by Vernon Barry Aug 5, 2012. 4 Replies

Why are my motors doing this weird power loss when running at approx. 75% throttle ? Thrust and amps go up nicely till about 75%, then suddenly I loose a lot of thrust and the amps actually go down.…Continue

No Mavlink, but console works.

Started this discussion. Last reply by Daniel Jun 19, 2012. 5 Replies

I have a ArduPilot Mega 1 (red, with oilpan "shield") that after the latest firmware update (Arducopter 2.6) doesn't seem to communicate via Mavlink anymore.Symptoms so far:- Firmware upload works.-…Continue

Tags: arducopter, firmware, crash, mavlink, no

 

Daniel's Page

Latest Activity

Daniel commented on Phil P's blog post New drone and Ground Control Station Trailer build
"I'm usually flying just on an open field near my work, but happy to catch up for a cuppa or something along those lines. Drop me a PM and I'll give you a call."
Dec 6, 2012
Daniel commented on Randy's blog post Steps toward ESC feedback using SimonK
"Marooned, just add a learning mode (record your baseline (while you are sure you still have all the props)) and then compare. And I was refering to this: https://www.sparkfun.com/products/9028?"
Sep 27, 2012
Daniel commented on Randy's blog post Steps toward ESC feedback using SimonK
"Wouldn't it be possible to compare the overall apms (as detected by attopilot sensor) to an "normal" amp use for a given rpm setting (for all motors) to detect a missing prop ? I know, still doesnt tell you which one is missing, but…"
Sep 27, 2012
Daniel replied to R_Lefebvre's discussion XBee airborne side antenna, how to replace?
"I assume variation in manufacturing."
Sep 9, 2012
Daniel replied to R_Lefebvre's discussion XBee airborne side antenna, how to replace?
"Which calculator thing did you use ? I used four different ones on the web and came back with the same…"
Sep 9, 2012
Daniel replied to R_Lefebvre's discussion XBee airborne side antenna, how to replace?
"Quarter wave for the frequency's used by the 900 xBee is between 80mm and 83mm. (902 MHz-928MHz)"
Sep 8, 2012
Daniel commented on narwhal's blog post Foreign Correspondent (ABC Documentary)
"I might have found it on the internet: http://www.slingfile.com/file/ZENvhyDwR0"
Sep 5, 2012
Daniel commented on Hooks's blog post New 5.8 Ghz wireless video system 1200mW Long Range
"Data in ? (in the picture) "
Sep 1, 2012
Daniel commented on Bertrand Duchiron's blog post RF Coverage Prediction (Worldwide)
Aug 13, 2012
Vernon Barry replied to Daniel's discussion Strange motor behaviour
"Right, so it's what I said, you have a faulty (AKA rating is higher than what it puts out) pack. Maybe it's only one cell that is weak, but the pack is not capable of providing power (constant Voltage and…"
Aug 5, 2012
Daniel replied to Daniel's discussion Strange motor behaviour
"Just checked, voltage direct on the ESC looks fine till the weird stuff begins. And as soon as I drop the throttle, it's immediately is fine again (can't be resistance, can it ?) "
Aug 4, 2012
Daniel replied to Daniel's discussion Strange motor behaviour
"The battery in the video is a 5000mah, rated at 20C. I pull at the time no more than 20 amps, i.e. 4C."
Aug 4, 2012
Vernon Barry replied to Daniel's discussion Strange motor behaviour
"First, don't believe the battery rating. Burst is not the same as continous. This is most likely the culprit. What battery exactly are you using? I got the feeling the ratings are way out of whack."
Aug 4, 2012
Daniel posted a discussion

Strange motor behaviour

Why are my motors doing this weird power loss when running at approx. 75% throttle ? Thrust and amps go up nicely till about 75%, then suddenly I loose a lot of thrust and the amps actually go down. Please see attached video for a better understanding.(This is done while bypassing the APM, and with a 100 amp capable battery, the ESC is rated to 25 amp, and my wattmeter never shows more than 25 amp (approx. 15 amp when the issue starts))See More
Aug 4, 2012
Daniel replied to Daniel's discussion No Mavlink, but console works.
"Thanks, that's it. I feel like an idiot now. Guess I should read the changelog before applying firmware updates."
Jun 19, 2012
gzebedin replied to Daniel's discussion No Mavlink, but console works.
"SOOO EASY!!! Thanks! I was searching for this for one day now! :-) THANKS"
Jun 19, 2012

Profile Information

About Me:
Me is a two character word.
Tell us a bit about your UAV interest
things, bits and pieces.

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Social Networking

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service