Trying to get this figured out....if anyone knows the fix it would be appreciated.ESC's are calibrated and also calibrated with Pixhawk.RC is calibrated in Mission Planner BUT during the Pre-Arm…Continue
I am stumped. Mission Planner was working fine and now it will no longer save the radio calibration. On the Pre-Arm check it says R/C Not Calibrated although the calibration has been completed. It…Continue
"Hi Garvarma, Sorry for the delay. I did watch the video. Here are my thoughts:
There are two separate calibrations that need to be done with the ESC, the first is the programming with a programming card. Then there is a second…"
"Hi Dene again,
Today I try to configure again turnigy now, i can move by all flight modes in mission planner, so i think that turnigy now is correct configured.
The problem continue, when i try to make calibration of ESC by pixhawk, and don't…"
First of all thanks for help. I have some doubts about your explanation.
When you say arm the controllers what do you refer? How i can do this arming?
Today i decided to restore pixhawk and turnigy 9x and start again from the beggining.
"Hi Garvarma, It may be that your radio needs a slight adjustment and is not arming which is probably the reason why the motors are not moving. To trim your throttle stick, go to the SETTINGS and scroll done to DISPLAY. Once in DISPLAY…"
I'm mounting my first quadcopter with this hardware:
- Pixhawk clone
- 4 sunnysky 980KV
- Emax 4 in 1 ESC
- Turnigy 9x version 2 with receiver
- ppm encoder sum
I follow all videos from your website and can't make work the 4 motors. I…"