"How did you come out......Don"

"I'm actually using my own, it's identical to the Cinestar 2 axis, functioality should be the same...........Don"

"cirilo, Another question, are you using the pots for the roll and pitch, with those servos, you need both pots as there are no pots in those servos. You don't need their pots, but for the pitch it is good as you have many more options with the…"

"It sounds like your tilt is reversed, go into MP and change the reverse box, check or uncheck, see what that does. Roll, is the servo using the internal pot, or do you have an external pot........ I assume you are using the APM 2 or 2.5,…"

"I have that same setup, it will work, I am using it with the APM 2.0 and 2.5. I had a problem with my roll oscillating, the pot I got from Quadrocopter was bad, I replaced with just a Radio Shack 5K pot, you do not need a 360 pot in the roll…"

"I am using the Cinestar with the APM 2.0 and have tried the 2.5 as well, connecting the servos to 10 & 11 on the APM. The pitch works wonderful, however the roll just wants to oscillate, bad enough that I cannot fly with it. It oscillates about…"

"I am using the APM 2.0 and Cinestar servo, and roll pot and cannot get the toll to stop oscillating with the Mission Planner configurations, any ideas......Don"

"A similar scare happened to me about a month ago with 2.81 on a hex. It was flying fair in loiter, seemed to want to search for the wrong heading. I switched to land in stabilize (I think), and for some reason I found it hard to set it down, then…"

"My throttle was at about 25% to hover. I changed my TX curve, now it hovers around center stick, but engaging loiter it drops, so I increase throttle on my TX, it then holds at about 75% stick. Then when I go back to stabilize it shoots up unless I…"

"Ok, I got that figured out, when in stabilize to hover my Futaba throttle/collective is about 25%, as soon as I engage loiter, it drops, so I move my throttle to the mid-point and it works fine. Do I adjust my curve on my radio, or something else.…"

"Thanks, that explains I.....Don"

"I have a similar problem since 2.9. No problems with 2.81. No sonar, stabilize works fine, however once in loiter, if I climb, it wants to keep climbing, if I command a down, even full down it takes about a second to start down, then it comes down…"

"Vishal, Are you still using the Nex5, if so how did you end up converting the HDMI to AV, I see Foxtech has a nice hdmi to av converter for $50......Don"

"I read somewhere that the bottom ones need to be a little larger to overcome the prop wash from the top ones. Have you experimented with different sizes."

"What size props are you using, are they all the same size....."

"UPDATE:  After getting similar symptoms when I replaced the APM2 with KK2 and also during a bench-test without any FC (just a 1-to-4 servo wiring), I am convinced that my problem isn't the APM2.I suspect it is ESC/motor-overheating.…"