Freddy Alcarazo
  • Male
  • Olmos, lambayeque
  • Peru
Share

Freddy Alcarazo's Groups

Freddy Alcarazo's Discussions

Build my first Rover How to Work Apm ?

Started this discussion. Last reply by Thomas J Coyle III Apr 16, 2015. 1 Reply

Hello Friends, I have in mind an idea, please help me. I'm very interested in build a ArdurRover, but I'm not sure how it works the apm.I have some questions ¿ArduPilot Mega is capable of control a…Continue

Tags: 2.5, Apm, ArduRover

 

Welcome, Freddy Alcarazo!

Latest Activity

Freddy Alcarazo replied to Diven Parker's discussion Build or Buy
"If you buy the 3dr solo, you are going to buy a lot of propellers and replace motors and you will throwing a lot of money to trash. But, this is good platform, but, the only problem was that I describe here. Cheap but.."
Mar 18
Freddy Alcarazo replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Hello dears.. Thanks a lot to all you... finally I could have a good flight.the problem was the calibration of weightsthanks so much.."
Nov 27, 2016
daniel arnoff replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Hi, Do you check the GPS otientation? Normally the white arrow must point front of the quad, as I can see in the vids in your case it seems the GPS is pointing to rear of the quad... Regards daniel"
Nov 23, 2016
Ray Quintana replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Oh Sebastian may have it.  I did that once on a race quad and the same thing happened, violent flips."
Nov 22, 2016
Sebastian S. replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Hi, did you check if the motors/controller are orientated correct? For me it looks like it powers the wrong motors. If you hold the quad in your hand and increase throttle to the point where it try to stabilize the two front motors should spin…"
Nov 22, 2016
Freddy Alcarazo replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Thanks dear, that is that I going to make after of my first flight"
Nov 18, 2016
Hans H. replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
Nov 18, 2016
Ray Quintana replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Looks like that left rear is lacking power.  I would recommend checking connections and ESC calibrations as recommended.  Also that the motor spins freely by hand."
Nov 17, 2016
Freddy Alcarazo replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"My friend. Thanks a lot for your recomendations... I only calibrated the accelerometer, compass with values (x 61, Y 0, Z - 27), my radio x9d and every channel has enable trim, also, the ESC's were calibrated and the props. I could push the…"
Nov 17, 2016
Qazi Ahmed replied to Freddy Alcarazo's discussion Apm 2.6 Impossible stabilization, what do you think about this problem? in the group ArduCopter User Group
"Hi, This is the very common problem for first time creators. There is a check list of to do's. First tell me did you calibrated your motors properly? Have you gone through all the procedures of your flight controller and firmware…"
Nov 17, 2016
Freddy Alcarazo added a discussion to the group ArduCopter User Group
Thumbnail

Apm 2.6 Impossible stabilization, what do you think about this problem?

Hello dears from diydrones.This quadcopter that I mounted using apm with AC 3.1.5 and the frame x alien..I did  a cheap power distribution board for give supply energy to four motors, but I don't have idea if this is the problem or the problem is with the compass.. I want to you watch this videos and I wait a reply of his experiences with quadcopters for report the problem.thanks a lot.See More
Nov 17, 2016
Freddy Alcarazo replied to Freddy Alcarazo's discussion Build my first Rover How to Work Apm ?
"Hi  Thomas  Thanks for your reply. The wiki is very complete. I see a little and I found a picture, where indicates that a servo is used to control the course of the…"
Apr 16, 2015

Admin
Thomas J Coyle III replied to Freddy Alcarazo's discussion Build my first Rover How to Work Apm ?
"@Daniel, You can start by reading the ArduRover Wiki Link  Regards, TCIII AVD"
Apr 16, 2015
Freddy Alcarazo posted a discussion

Build my first Rover How to Work Apm ?

Hello Friends, I have in mind an idea, please help me. I'm very interested in build a ArdurRover, but I'm not sure how it works the apm.I have some questions ¿ArduPilot Mega is capable of control a servo for calculate which way to turn?.Ie if ordered score 3 points in mission planner. When my car is in motion and reaches the first point Will rotate the servo ?. To test this would not be obligatory set the engines, could see myself walking and when you get to the second point of land registered…See More
Apr 16, 2015

Profile Information

About Me:
ArduCopter User Group
Please tell us a bit about your UAV interest
Drone Pilot - Developer
Hometown:
Peruvian

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service