"You sir, are my hero! I was at the point of RMAing my board (that used to work perfectly) when I changed my comm port from 6 to 15. Before I was getting garbage on the CLI and the board would not connect. Could not even update the…"
"I contacted 3D Robotics...They reply and send me RMA# ... but still waiting for a FEDEX Label ....
They said they will test it... it will be changed if it is bad and no clues that repairing attempts happen. "
"Hi Chris, I can connect through CLI, can do all CLI tests except INS whereupon it hangs, I can upload ArduCopter firmware without error, but I cannot connect with USB, always times out, one blue LED (c) is on permanently. If I check "reset APM…"
"My APM 2.5 also hangs .... LED C"blue" lights, but LED B & C are off .... I am able to upload firmware so I believe that bootloader is working...
it seems I have an issue in Baro or Gyro .... I believe that because of attached CLI…"
"Hi all, I'm a newbie on the community writing from Argentina. A couple of weeks ago I've ordered by very first APM 2.5.
I have a similar behavior to the one described here. I'm able to upload the latest ArduPlane firmware(2.65) and…"