Jaivon Jackson
  • Male
  • West Babylon, NY
  • United States
Share

Jaivon Jackson's Groups

Jaivon Jackson's Discussions

Motor 5 and 6 will not arm.

Started this discussion. Last reply by Jaivon Jackson Mar 24. 5 Replies

Hey everyone. I know this had to be answered some where before. I have looked and really never found a fix.  So here goes. APM 2.8 Latest firmware installedDJI F550 CloneFlysky 6 channel Radio4S…Continue

 

Jaivon Jackson's Page

Latest Activity

Jaivon Jackson replied to Jaivon Jackson's discussion Motor 5 and 6 will not arm.
"Ok quick update...I hope this might help someone else. What I had to do was load rover on first... then load Hex firmware, all motors arm and spin... "
Mar 24
Jaivon Jackson replied to Jaivon Jackson's discussion Motor 5 and 6 will not arm.
"Looks like with the PIX I have to also do a PPM from my receiver?  I have a FlySki i6"
Mar 24

3D Robotics
Chris Anderson replied to Jaivon Jackson's discussion Motor 5 and 6 will not arm.
"Well, of course I use Pixhawk Mini!  I don't have any vehicles large enough for Pixhawk 2 (it's huge), but some other choices are here. "
Mar 24
Jaivon Jackson replied to Jaivon Jackson's discussion Motor 5 and 6 will not arm.
"Hey thanks Chris Thanks for the reply...I want to say yes. I have loaded and reloaded even tried the Octacopter firmware to see if that would change anything. Im going to try a different computer and see if maybe that could me it. And yes I started…"
Mar 24

3D Robotics
Chris Anderson replied to Jaivon Jackson's discussion Motor 5 and 6 will not arm.
"You're sure you loaded the hexacopter firmware and not the quadcopter? You probably already know that APM 2.8 is not supported anymore with the latest firmware. You should be using a 32-bit controller, such as Pixhawk or its clones. "
Mar 24
Jaivon Jackson posted a discussion

Motor 5 and 6 will not arm.

Hey everyone. I know this had to be answered some where before. I have looked and really never found a fix.  So here goes. APM 2.8 Latest firmware installedDJI F550 CloneFlysky 6 channel Radio4S 400MAH920KV MotorsSIM 2-4S ESC Red LabelDid all ESC calibration Once done motor `1-4 respond motors 5-6 do not spinIf you unplug and and plug back motors 5-6 will spin with no control, 1-4 will do nothing and will not arm. I have reinstalled firmware tired different one, not change. I have also attached…See More
Mar 24

Profile Information

About Me:
Director of Programs 95.2
Please tell us a bit about your UAV interest
New to Multi, with over 30 Years in RC Cars
Hometown:
babylon

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service