Jan Kaas
  • Male
  • Den Helder
  • Netherlands
Share Twitter
  • Blog Posts
  • Discussions (3)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Jan Kaas's Friends

  • Jose Julio

Jan Kaas's Discussions

Inertial navigation in Arducopter

Started this discussion. Last reply by Tom Yochum Nov 22, 2011. 1 Reply

Hello,I'm working on a project with an Arducopter and I want to switch to Inertial Navigation to navigate from waypoint to waypoint (which are programmed into the autopilot) in the event that the GPS…Continue

Tags: GPS, jamming, Secondary, Navigation, Inertial

Arduino code upload problems (for attopilot current sensor)

Started Nov 21, 2011 0 Replies

Hello there, I'm having major problems the last few days with uploading an altered code with arduino to set up the attopilot current sensor succesfully. So I try to follow the manual as close as…Continue

 

Jan Kaas's Page

Latest Activity

Tom Yochum replied to Jan Kaas's discussion Inertial navigation in Arducopter
"Hi Jan, The arduino does not have enough processing power to run an inertial navigator in addition to the autopilot code. Try checking out Open Pilot.   Tom"
Nov 22, 2011
Jan Kaas posted a discussion

Inertial navigation in Arducopter

Hello,I'm working on a project with an Arducopter and I want to switch to Inertial Navigation to navigate from waypoint to waypoint (which are programmed into the autopilot) in the event that the GPS signal is lost for whatever reason. Has anyone already worked on or experimented with this kind of secondary navigation? Thanks, JanSee More
Nov 22, 2011
Jan Kaas posted a discussion

Arduino code upload problems (for attopilot current sensor)

Hello there, I'm having major problems the last few days with uploading an altered code with arduino to set up the attopilot current sensor succesfully. So I try to follow the manual as close as possible.I deided to use the onboard (APM) voltage sensor, so I soldered a 3.9KOHM resistor on the AN0 position, and the attopilot chip for measuring the current drawn.In the end of the manual it says to alter the firmware in arduino ( in the APM_config.h right?) and define the VOLT_DIV_RATIO to 12.6.So…See More
Nov 21, 2011
Jan Kaas replied to ARHEXA's discussion how to choose motors for Quad ?
"Hy!   I started to build my first Arducopter. Now, I am wondering which of the props. (10 or 12) you recommend to get the best results for short flying and long hovering.    Thanks in advance!  "
Nov 12, 2011

Profile Information

About Me:
Technical Student
Please tell us a bit about your UAV interest
I've justed started a new project with the arducopter. I'm pretty new to this all
Hometown:
Den Helder

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service