Janis Dzerve
  • Male
  • Latvia
Share

Janis Dzerve's Friends

  • Janis Kuze

Janis Dzerve's Groups

 

Janis Dzerve's Page

Latest Activity

Janis Dzerve replied to Tom Hallman's discussion UgCS with 3DR Solo? in the group UgCS
"Tom, You can try to connect it via UDP over wifi and it should work, but it is not officially supported by UgCS. Add these lines to the vsm-adrupilot.conf and restart the VSM: vehicle.ardupilot.udp.1.udp_local_port =…"
Jan 17
Janis Dzerve replied to Peng Cheng's discussion How to add a non emulated quad/plane/SITL? in the group UgCS
"1. On VSM config. Add two lines to vsm-ardupilot.conf: vehicle.ardupilot.tcp.2.address = 127.0.0.1 vehicle.ardupilot.tcp.2.tcp_port = 5762 If you are running the simulator on other host or virtual machine then substitute the 127.0.0.1 with the ip of…"
Dec 27, 2016
Janis Dzerve replied to CyberFreakTeam's discussion UGCS UDP form APM: Arducopter with Rpi2 Erlebrain 2 in the group UgCS
"Hi, For UDP to work UgCS requires a separate config entry for each vehicle in vsm-ardupilot.conf. Given the following network setup: Host running UgCS: 10.0.0.10 IP of Vehicle1: 10.0.0.11 IP of Vehicle2:…"
Dec 19, 2016
Janis Dzerve replied to Gary Epstein's discussion Connecting UgCS to ArduPilot with UDP and MAVProxy in the group UgCS
"Matt, Thanks for your interest. It is possible to make mavproxy+UDP to work with UgCS but it is somewhat involved. UgCS can connect to autopilot via UDP only if you know the remote address and UDP port of the vehicle (or mavproxy) in advance and…"
Dec 19, 2016
Janis Dzerve replied to Robert Matthews's discussion Exceeding waypoint limit with DJI A2 in the group UgCS
"Rob, A2 will not accept more than 50 waypoints. There is a feature in UgCS which allows you to overcome this limitation by uploading partial route. It involves manual route upload in the middle of the mission. You should decide if that can work for…"
Nov 9, 2016

Profile Information

Please tell us a bit about your UAV interest
Like it.
Hometown:
Riga

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service