Here a video of an autonomous flight with a Maxi Swift flying wing fully piloted by the firmware ArduPlaneNG v2.x R5 with an All In One Pro (AIOP) full IMU board.This is a porting of the ArduPlane v2 (v2.4+v2.5) firmware and special addons and improvements for the AIOP board that I have added.

The wind was 15 km/h gusting 22 km/h. The flight was very stable in spite of the gusty wind conditions.

Setup:

• IMU board: All In One Pro (AIOP) v1.0 from…

Here a video of a full autonomous test flight of my Easyglider e-Glider piloted by the firmware ArduPlaneNG v2.x R4 and an AIOP (All In One Pro) full IMU board.This is a porting of the official ArduPlane v2 firmware with special addons and improvements for the AIOP board that I have added.

The flight was very stable in spite of the gusty wind conditions, the wind was blowing at 18 km/h gusting 35 km/h..…

Here a video of a test flight of the ArduCopterNG v2.7 with the All In One Pro IMU board (AIOP). The official release of the ArduCopter v2.7 firmware for APM has been ported and tested successfully in flight on a quadcopter with an All In One Pro (AIOP) v1.0 full IMU on board by Jean-Louis Naudin on July 29, 2012.

Avionics:

- Full IMU: All In One Pro v1.0 (AIOP) from CRIUS

- GPS: Mediatek MT3329 (10hz)

Firmware:…

[UPDATE: This project is now being ported to a proper Google Code repository and manual. For instructions, start there. You can also join the ArduRover User Group here.]

Hello to ALL, the new firmware for APMRover v2 has been tested successfully on my rover on may 1st, 2012 on full autonomous reco mission following a navigation plan. This new release of the APMRover v2 works on the APM v1.4 with the OilPan shield (magnetometer + MT3329 GPS) and also of course on the APM v2. The previous version of the …

This is spring time and thus the ThermoPilot project is still under intensive development (now the v6.x version) and real tests flights can be conducted because the thermal upwards can be hunted above the fields... Below a sample log flight during a full autonomous thermal hunting in free mode.…

Here some videos samples of 8 full AUTO-LANDING tests flights that I have done with the firwmare ArduCopter v2.4xp1 (JLN mod). I have updated the official ArduCopter v2.4 firmware with a special Auto-Landing mod that I have developped and tested successfully in the previous v2.2xp2 release.

In the video you will see, full tests of the:

- STABILIZE mode (full manual flight evolutions),

- LOITER mode (GPS position hold),

- and 4 samples of FULL AUTO-LANDING with the v2.4xp1

The quadcopter is firstly set in LOITER mode and then the AUTO-LANDING is trigged by the Switch 7 of the transmitter. Setup: ArduPilot Mega v2 + Firmware ArduCopter v2.4xp1, Frame: Quadcopter DJI F450 Flame Wheel (X mode)…