Hey all, I had quite a few of the parts for the OSD already so I downloaded the source files from the diydrones store site and sent them off to be fabbed, but as a friend and I were assembling our…Continue
"Threadlocker should have been there, if not from the factory then after the first motor came loose. Also checking threadlocked screws does NOT involve trying to tighten them. If you do successfully tighten one then you just broke the…"
"While they now at least have some regulations, I think they have misworded something in a bad way. The current wording of this means that every helicopter with a flybarless unit on it falls under these rules. According to this you should…"
Hey all, I had quite a few of the parts for the OSD already so I downloaded the source files from the diydrones store site and sent them off to be fabbed, but as a friend and I were assembling our boards today we noticed that we had boards marked V0.1 in the silkscreen and the file was listed as version 0.5. Could we get someone to update the webpage with the proper source files for the new board so I can order up the latest and greatest pcbs?Thanks!Or maybe the source files are in the wiki? …See More
"Your ESC is overheating because the BEC inside it is a linear bec and is putting out a lot of heat as it regulates the 11.1v down to 5v for your servos and autopilot. If you want to cure this put in a seperate switching BEC at least when you…"
"Chad, what you needed was an F connector Male to an SMA female adapter. Something to watch out for is that SMA and TNC connectors can be reverse polarity. Meaning the pin/socket of the connectors is reversed, there are pins where there…"