"I had this problem, I just swapped the RC channels on the receiver so that the throttle and yaw were on the same sticks."
Matt Ponce's Discussions
Motor Speed Problem
Started this discussion. Last reply by Sebastian Gralla Mar 5, 2011. 5 Replies 0 Likes
So I have the board up and running and the configurator returning good values. The transmitter also appears to be sending a good signal. The problem is that whenever I turn the throttle up on all 4…Continue
Arducopter Ordering?
Started Jan 28, 2011 0 Replies 0 Likes
What is the news behind the Fahpah website removing all the kits? Are the kits still going to be sold? Also are there any alternative places to order the kit that actually have some in stock? Been…Continue
Matt Ponce's Page
Latest Activity
Sebastian Gralla replied to Matt Ponce's discussion Motor Speed Problem"as I wrote above, your radio trims not set to make a clear 1500 signal, your yaw will drift
nothing else, it's completely independed of flight mode/motors/ESCs/power distribution/etc"
Matt Ponce replied to Matt Ponce's discussion Motor Speed Problem"+ Config
Left and right (1 and 0)
All arducopter gear as provided from fahpah, default motors.
Magnetometer is connected, and enabled through the configurator.
Makes sense what Sebastian said about yaw.
Thanks a lot guys."
Aryeh Marks replied to Matt Ponce's discussion Motor Speed Problem"I have exactly the same problem and the only way around it for me is to add a touch of right yaw.
The motors that slow for me are the number 0 and 1 outputs (those are, the right and left ones when viewed from above)
I'm sure this is something…"
AdminJohn C. replied to Matt Ponce's discussion Motor Speed Problem
"+ or x config?
Which 2 motors?
Arducopter power distribution, ESCs and motors?
Magnetometer connected?"
Sebastian Gralla replied to Matt Ponce's discussion Motor Speed Problem"yes, that's yaw
you will not notice it while flying
to reduce it: trim your radio yaw channel to be exactly 1500"
Matt Ponce posted a discussionMotor Speed Problem
So I have the board up and running and the configurator returning good values. The transmitter also appears to be sending a good signal. The problem is that whenever I turn the throttle up on all 4 motors, 2 will always lose power very slowly. This is reflected in the configurator as well. I began by testing the ESC's and power distribution. I plugged them all into a parallax board and ran them through tests running 1, 2, 3, and 4 motors at a time full power, no problems. I have tried disarming…See More
Matt Ponce posted a discussionArducopter Ordering?
What is the news behind the Fahpah website removing all the kits? Are the kits still going to be sold? Also are there any alternative places to order the kit that actually have some in stock? Been trying to get one for a couple months now, always seem to be a day to late.See More
Profile Information
- About Me:
- Rawr
- Tell us a bit about your UAV interest
- I luv arducopter
Comment Wall
- No comments yet!
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
Andropilot Users Group
203 members
-
Melbourne
54 members
-
Spanish arducopter Users
88 members
-
Moderators
24 members
-
ArduPlane User Group
720 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
