"I'm using this camera: http://www.rangevideo.com/index.php?main_page=product_info&prod... (NTSC) and it's ok with the minimOSD. But I tested this…"

"I'm using this camera: http://www.rangevideo.com/index.php?main_page=product_info&products_id=277&zenid=540f0908507306f684a7cf4bd41c19a2 (NTSC) and it's ok with the minimOSD. But I tested this…"

"somebody has the PID of the SkyWalker 168cm? thanks"

"now ok!!!! I used the MinimOSD_20.hex and the Config_OSD_20.zip and all works great! And I upgraded the charset with feeding the MinimOSD with lipo 12V at same time with the FTDI cable. Thanks!!!!!!!!!!!"

"now ok!!!! I used the MinimOSD_20.hex and the Config_OSD_20.zip and all works great! And I upgraded the char with feeding the MinimOSD with lipo 12V at same time with the FTDI cable. Thanks!!!!!!!!!!! "

""Both sides of the MinimOSD need to be powered during a Character Set updating": I feed with 12V (camera, tx video and MinimOSD). I need to plug de battery when the FTDI cable is conected to update the charset? thanks"

"I'll try this. I feed the MinimOSD with 12V lipo when in use. I need to feed with this battery while I put the FTDI cable to update the char set?"

"I use the OSD today... I had some problems: some symbols was different (this I noticed since I tested), horizon wrong (somebody here already has this)... see the picture.  I'm using: Config tool for 1.30.x and 2.0.x…"

"is possible show the mAh that was consumed instead of the battery percent? I use battery os 5000, 2600mAh... if I know how mAh was consumed I will know how percent my battery has."

"yes! work! Need to put  "#define RECEIVER_RSSI_PIN 6" on wiki...  ..."If you use APM2 or 2.5 than add: "#define CONFIG_APM_HARDWARE APM_HARDWARE_APM2" in APM_Config.h  AND  "#define…"

"hello, I compiled and upload... (I removed "//" and compiled, this is?). But RSSI wasn't showed. I checked the box "RSSI Enable Raw" and didn't showed the raw values (tx on and off). I cheked at pin of port 8: (-):…"

"hello, I'm downloading arduino to add "#define CONFIG_APM_HARDWARE APM_HARDWARE_APM2" and compile. I thought that wasn't to compile. I will try. Thanks"

"hi... I'm using the DragonLink too. I conected the RSSI out of receiver to the APM port 8. But at screen (OSD) only show 0% or 1% (radio on and off). What do you did to work? See how I conect (pictures). Thanks "

"hi, this MinimOSD: http://www.ebay.com/itm/F03018-3DRobotics-MinimOSD-OSD-board-Support-APM-APM2-RC-flight-control-board-/120958504526?pt=LH_DefaultDomain_0&hash=item1c29b04e4e is a copy? works? thanks"

"ok! Thanks!"

"hi, I tested the NTSC version: ok now! At NTSC the letters is too big! have any way to reduce? At PAL I think the letter ok... but my cam is NTSC. Thanks"