This may be a neewb question but its been driving me crazy, For the last two weeks I've been building a TBS F450'ish quad and I finally got it all put together. I programmed it with the latest…Continue
"Figured it out thank you for all of your help. So I thought that the PDB would be wired correctly (for X quads) when it arrived but... It isn't. Motors three and four were reversed (I later checked the PCB and it is labeled I correctly) but if…"
"Its a X config. and I figured it out the PDB is wired for an + config so I rewired it and now it takes off very unstable but it takes off none the less. now my problem is that the Motors keep beeping every half second the AMP will say armed but the…"
"Do you have your quad configured in a + configuration or an X configuration?
Probably the most common reasons a quad flips would be:
1. motors or props spinning wrong way
2. quad is setup in a + configuration instead of an X configuration (or…"
"I thought so but because I'm using the 3DR PDB wouldnt it be impossible or do you think they could of soldered it? When I connect the apm to the terminal in Mission Planner and run the test "Motors" they spin CCW is that the correct…"
This may be a neewb question but its been driving me crazy, For the last two weeks I've been building a TBS F450'ish quad and I finally got it all put together. I programmed it with the latest software, Calibrated the gyro and compass. Also calibrated the turnigy plush 40 AMP ESC, with T-Motors. I have checked the direction of the motors and also have the correct push/pull props on the motors. -So the problem, is that when I go to fly in stabilize (or any other mode for that matter) mode…See More