Patrick Glennon
  • Male
  • Dallas, TX
  • United States
Share Twitter

Patrick Glennon's Groups

 

Patrick Glennon's Page

Latest Activity

Patrick Glennon replied to Edgar Scott's discussion Does Ch 7 Opt RTL override Auto mode? in the group ArduCopter User Group
"It does for me.  regarding the telemetry and radio range, I usually set up a geo fence as a failsafe.  I don't think those rely on radio or telemetry range, but I've not actually tested it. -Patrick"
Jan 27
Patrick Glennon replied to Alexandre Nascimento's discussion How flat the quad need be to fly? in the group ArduCopter User Group
"did you set levels in the mission planner?  That helps drift for me.  I try to do it regularly."
Jul 21, 2012
Michael Visser replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"I've experienced the same broken motor mounts issue which has resulted in either a severe or 'fingers crossed' emergency landing. I'm now using a new frame and metal mounts to get around this. The battery straps are paramount,…"
Jun 8, 2012
Patrick Glennon replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"I am using APCs, and just ordered 8 more, after cleaning out the 4 from the local hobby shop I need to replace the ones that tried to eat the fence.  Thanks!  Looking forward to no wind so I can get back to flying/testing... "
May 9, 2012
Patrick Glennon replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"great suggestion, thanks!!"
May 9, 2012
Rui Manuel Cravo Marques replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"Don't forget to use good propellers also. APC or those new ones Cf reinforced. Cheap props tend to break under stress after 2 or 3 flights, and they don't warn you when they are going to break."
May 7, 2012
Rui Manuel Cravo Marques replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"That's what I use to do also and no problems with motors."
May 7, 2012
Randall Richmond replied to Patrick Glennon's discussion Early flight test lessons in the group ArduCopter User Group
"Hey, instead of soldering everything how about getting some shrink wrap and wrap the bullet connectors then all you have to do is cut the wrap to replace any bad parts etc... Randall"
May 6, 2012
Patrick Glennon added a discussion to the group ArduCopter User Group
Thumbnail

Early flight test lessons

So, finally got my APM2 a week ago, got it set up, and did my first flight:Right off the bat, it was listing HEAVILY to the right, not flipping over, but required a lot of stick to keep it stable.  I looked at the mounting of the APM board with sticky foam tape and made sure it looked level.  I went through all the setup all over again, from the beginning.   I read a ton of forum and troubleshooting suggestions, and remembered how much I laughed when people screwed up the + vs X config, and…See More
May 6, 2012
Patrick Glennon replied to Bradley J Carr's discussion How much wind is to much for the 3dr quad? in the group ArduCopter User Group
"Bigger props would likely not help.  Reading the AC2 tweaks page is your better bet.  There's some good discussions out there on why bigger props are not the answer, but basically you want a good balance between engine and ESC size,…"
Apr 20, 2012

Profile Information

About Me:
I work in information technology, love russian literature and all things tech, speak a few languages, and love pina coladas and walks in the rain.
Tell us a bit about your UAV interest
My father was a pilot, so I grew up playing with paper and cardboard planes and models. I work in information technology, and have always been fascinated by robotics and vehicles, but have not had much time to explore the interest
Hometown:
San Francisco

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Social Networking

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service