"Hello David, You also need to have the data stream rates configured correctly. To do so, connect to Mission Planner. Go to configuration. Locate EEPROM parameters and verify that you have the following parameters configured as…"

"Hello, Have you also added the "#define RECEIVER_RSSI_PIN 6"? If yes, please double check the analog port number you are using. Be sure it is number 6. If not, either change the 6 by whatever pin you are using or change the connection in…"

"Hello Medeiros, Have you followed this procedure to configure RSSI? Pedro"

"Hello Josh, Glad you like it! You can found the project code here. Pedro"

"By the way, Last stable .hex with 115200 baudrate. Pedro"

"Hello Jim, Yes the firmware I provided is a pre-release. I've not understood why you are not using the telem UART. Is there any particular reason? Pedro"

"Hello Jim, "I'm currently running 115 K baud on port 0. I'm not sure that you can change that since it's also the USB port on the APM." Let me see if a understood. You have minimOSD connected to UART0 in APM? The same…"

"Nathaniel, Don't apply any scaling. Please confirm that you are using the last CT (Config tool for 2.1.x (V2.1.2).zip) and the last pre-release firmware (MinimOSD Extra 2.1.4 Pre Release Version r310.hex). The CT will not work with an old…"

"Hello Nathaniel, The Raw values are 0-255. But depending on your RSSI the RAW value can have different min and max. Just enter this min and max in CT and it will scale it to 0-100%. Also remember to turn off the display raw. What version of CT and…"

"Hello, You can download the new firmware (still pre-release) and the new configuration tool here. This includes a small modification of Call Sign panel (now all letters are lower case) and also a new option to control characters brightness. Enjoy…"

"Hello Putra, Glad to hear that it is working now! I will add a note in the wiki to make clear to everyone! Pedro"

"Andke, As I seen in the link it clearly states that it is using Mavlink 1.0. So this is not the problem here. Pedro"

"Hello Putra, Yes there is a special step! Please connect to Mission Planner. Go to configuration. Locate EEPROM parameters and verify that you have the following parameters configured as…"

"Hello Putra Abbas, First of all, do you have TX and RX pin connected to MinimOSD? If you have please unconnect the TX pin and see if you have the same behaviour with MinimOSD and MinimOSD-extra. If yes, this a problem related with the data streams…"

"Hello Burt, Ok seams logic to be all lower-case. I will revise this in the afternoon and make a new download. Pedro"

"Hello, The new Call Sign is ready! You can download the new firmware (still pre-release) and the new configuration tool here. Enjoy and please give feedback! Pedro"