Rodney wells
  • Male
  • Victoria
  • Australia
Share
  • Blog Posts
  • Discussions (7)
  • Groups
  • Photos
  • Photo Albums
  • Videos
 

Rodney wells's Page

Latest Activity

Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"Do you use Mission planner or Q ground control"
Oct 23, 2016
Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"Hi Guys. I purchased a AUAV Pixracer almost 6 months ago at the time I had limited success. So I put it away and just keep an eye on this thread. and after following the progress of the Pixracer for some time now seems like time to get it out and…"
Oct 22, 2016
Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"This was my problem Spektrum will not decode as yet on the Pixracer. Some here said it would but I could not get it to decode no matter how may things I tried.    My solution was to buy a PWM to PPM and Sbus converter. I also purchased a…"
Jun 8, 2016
Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"My new Pixracer controller fly's today in a HK dead cat quad. After a week of learning Q-Ground control and Mission planer, twirling and rotating it around trying to calibrate the sensors it finally gave the thumbs up to arm and test fly. It…"
May 28, 2016
Rodney wells replied to Fabrice's discussion Pixracer + Copter V3.3.4-rc3 : DSMX, CPPM not working, S-BUS working
"Same Here. I have been working on the Spektrum Satellite issue for 2 weeks. No go. I used a converter to go to PPM and SBUS that works with errors if the error messages are correct. Also waiting on a FRsky System. But so far the RixRacer is not…"
May 23, 2016
Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"I have tried ever combination of firmware available past present beta.  All I get is spektrum not supported or bind failed. I have orange receivers and original spectrum DSMX and DSM2. I never had seen the receiver go into bind mode. The system…"
May 14, 2016
Rodney wells replied to Randy's discussion PixRacer with Ardupilot
"I just received my Pixracer board and I cannot get a bind with DSMX receiver. Will the Pixracer communicate with a DSMX Spektrum satellite receiver? Are there others on this forum that uses Spektrum DSMX. The yellow Tab that appears down the bottom…"
May 10, 2016

Profile Information

About Me:
I am a keen RC flyer been fling RC something since 1978. I own a large number of Planes and Helicopter. Trex 700 DFC raptor 50s. Now I am flying drones going to give FPV a try I also have a computer and electronics back ground.
Please tell us a bit about your UAV interest
I own a 2 drones and they use CC3d and MultiWii Mega EZ3 Black
Hometown:
Sunbury

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service