"And I thought this day couldn't get any better :) Now I can run the my payload GCS independently with the joystick interface... SWWEEEETTT!"

"Hello Bill, At the moment we have tested Multipoint firmware on RFD900s, but will test and release it for 3DR modems through early next week.  You will have to upgrade with the RFD900 config tool until 3DR Radio config and APM planner get…"

"Is there a version of the multi-point available for the 3DR Radios, or do you need both RF900 for that mode? Thx"

"A group called : Edge Research Labs  has done some testing with the modems out to around 67km without any issues.  Their website has more information on the antennas they used.  The configuration you also suggest also sounds…"

"We have been working on a multipoint software solution for the RFD900 and it is now available for download! :) We have tested it in house, and have not seen any issues, but, being a new release, make sure it works well in your application. The user…"

"I'm about to by the RFD900 2 radio kit. It will used onboard my high altitude balloon (30,000m) connected to a px4fmu+io. Do you have a recommended antenna setup for this? would the 2 yagis from your site 90 degree polarization for the ground…"

"I love drones and I agree with the ranchers. If you are against some ones activities and announce your are going to film them and use it against them, not to mention the manned helies. They should be shot down. If you were working for the rancher he…"

"Hi Sean, The RFD900s and 3DR radios are preset with flow control turned off. The only connections that are needed for both are, GND, TX, RX, +5V Things that are worth checking out are to see the green link LED is solid on both sides - if it is…"

"Hi MV, I have had a look at the Ardustation and it looks like it should interface nicely to the RFD900 with the correct hookup: +5V, TX, RX, GND... - Will be interested to hear if you give it a go!, Cheers, Seppo"

"Awesome. Is it compatible with the ArduStation with a bit of soldering? "

"Nice!"

"Thanks Dan. I did a long range flight today out to 2.5km and the signal strength in mission planner didn't drop below 98%, so I may even drop the dBm another notch to save more power.  Here in Australia, the ERP limit is 30dBm. I'm…"

"The schematic does show the PWM and IO/sensor 5V pins all being connected, so it makes sense that this works for you. About the radio output... it is indeed good radio practice in general to not transmit with any more power than you need.  As…"

"Thanks Dan, I'll give that a go at some point. I've just returned from 2 hrs of flying with my new setup. It seems to be working for me now, I am getting stable voltage readings while using the RFD900. I have reduced it's the output…"