Simon Vleugels
  • Antwerp
  • Belgium
Share
  • Blog Posts
  • Discussions (4)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Simon Vleugels's Discussions

Pixhawk motors stop

Started this discussion. Last reply by Kurt Kreiger Dec 5, 2017. 2 Replies

Hi,This is my first time I have been using a drone. I'm using a quadcopter with a pixhawk running PX4 firmware. I'm testing my drone without props connected to a power supply. When I increase the…Continue

Tags: pixhawk, px4, Motors

 

Simon Vleugels's Page

Latest Activity

Kurt Kreiger replied to Simon Vleugels's discussion Pixhawk motors stop
"Also depending on what flight mode you are in, the controller is expecting to see some movement and if it is not, it gets "confused" and you will have weird behavior of motors. Try same experiment and move the quad around so the motors…"
Dec 5, 2017
Clive Gregory replied to Simon Vleugels's discussion Pixhawk motors stop
"Without more detail I can only make one suggestion: With propellers disconnected there is very little resistance torque so the motors spin up very easily. Any slight differences in the ESC calibrations can cause some motors to stop near to throttle…"
Dec 2, 2017
Simon Vleugels posted a discussion

Pixhawk motors stop

Hi,This is my first time I have been using a drone. I'm using a quadcopter with a pixhawk running PX4 firmware. I'm testing my drone without props connected to a power supply. When I increase the throttle the motors start spinning normally but when I hold the throttle for a time on the same level, some motors stop spinning. But when I change the pitch or roll, they start spinning again. Is this normal? I'm just a beginner.Thanks!See More
Dec 1, 2017

Profile Information

Please tell us a bit about your UAV interest
thesis
Hometown:
Lint

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service