"I have the Hexa C from 3D Robotics. I have yet to perform an autonomous flight mainly because I can't find the docs on where to alto launch, fly wp's and then RTL. How do I make the transition from flying with my DX8 to autonomous, mission…"

"No one answered BR928's other question. How do you reset the mission to Takeoff is armed again. I have found that I need to re-write the mission before each take-off. Is there an easier way? Is there a way that doesn't require mission…"

"Thanks for the info. In 'Auto' mode it should work. My question, how 'Takeoff' mode works?"

"TAKEOFF is pretty much set an angle and a altitude you want it to go to. After that point the plane into the wind, flip into auto mode and toss. The throttle usually revs up to full unless you've done some other settings. After the APM reaches…"

"Hi all, I just setup my Arduplane using firmware 2.73. In mode option, there are 'TAKEOFF option. Did somebody try it? How it work? Can I'm using it for auto control to hand launch my plane? The description in manual not so detail..…"

"Does anyone know how to Do this flash using a isp programmer.  My apm is not seen in windows at all and i cannot get it into DFU mode.  any ideas? "

"Hi Bob, Can you see where in the code that is implemented? I don't find it.. In static void update_current_flight_mode(void) {    if(control_mode == AUTO) {       …"

"Hi, tomorrow in going to make my first auto take off mission, but like you i have a question? when i hit auto the throttle goes to max. I read the reply beneath but i thought the throtlle would automatically activate when launching the plane (when…"

"After powering both sides of the OSD the character set did download properly."

"Great work on the OSD."

"I am enjoying all the progress Gabor has made with this. I was just about to change the units from metric to US and you have already done that and added a setup menu too. Good job!   I am still can't upload the new character set for some…"

"You have all the symptoms of a 'black screened/fried" OSD. I just received my third one today. I am very nervous experimenting with it now! Let me ask you this. Were you powering the digital and analog side separatly? APM powering the…"

"  My 3rd MinimOSD is supposed to be on its way after blackscreening (fried) the first two. 3DR can't tell me why this is happening and went as far as telling me I can power the APM (digital +5V Mavlink) and the video side of the…"

"So the ArduCam_OSD _Beta is the original source and can be deleted? I was able to get your G1.22 ArduCam_OSD to compile using Arduino 0100-relax and 1.0.1 without any errors. The Beta still will not compile but that is not a problem if it was the…"

"Using Arduino IDE 1.0.1 I am still getting compile errors.  Says conflicting return type associated with uint8_t. Any ideas? There are 2 source codes in your zip file. Is the OSD the original and the beta your changes?"

"I was using 5v from the APM2 to the ftdi side of the minimOSD. I was using 12V from a second battery to power the camera, transmitter and video side of the OSD. The wiki does not show the main battery powering the APM. When I powered the OSD and the…"