"Did you get it to bind? I just received mine and was able to bind it. If still have issues let me know and i will try to explain the process."
-
Stanley Pisarski
- Male
- Portage, PA
- United States
- Blog Posts
- Discussions (8)
- Groups
- Photos
- Photo Albums
- Videos
Stanley Pisarski's Discussions
3dr 915 MHz radios Cannot receive any telemetry. Times out ..no heartbeat packets!
Started this discussion. Last reply by Stanley Pisarski Aug 9, 2012. 2 Replies 0 Likes
I bought the 915MHz 3DR radios and I am having the same problem. The ground and air radios link together and I can run mission planner 1.0 with the the APM2 using the USB cable but when I disconnect…Continue
walkera radio and rexeiver questions need help
Started Jun 11, 2012 0 Replies 0 Likes
I just bought a Walkera Devo 12s transmitter and several rx1202 receivers and i am having trouble binding the transmitter to the receivers.Continue
walkera 12s and rx1202 receiver
Started this discussion. Last reply by Russ Gadagno Jan 18. 1 Reply 0 Likes
I just bought a Walkera Devo 12s transmitter and several rx1202 receivers and i am having trouble binding the transmitter to the receivers. If any body can point me in the right direction to get a…Continue
Stanley Pisarski's Page
Latest Activity
Stanley Pisarski replied to Luc van Helfteren's discussion 433 Mhz radios will bind, and config utility works but no heartbeat"I am using the UART marked U0/U2. The one that is called out in the instructions for the APM2 and the 3d robotics radios on the 3d robotics web site.
Stan Pisarski"
Stanley Pisarski replied to Luc van Helfteren's discussion 433 Mhz radios will bind, and config utility works but no heartbeat"This is what happened in my case. Temporary solution in my case described below.....I have found the problem. It relies with the APM2 board. No matter what baud rate I set the APM2 for telemetry using the usb cable and mission…"
Stanley Pisarski replied to Chandan Roy's discussion HELP "Failed to enter command mode" error"Try to change the baud rate that you are using in the radio configurator software or in mission planner once you have uploaded the firmware. Don't assume that it is set up for 57k baud. I tried every baud rate until I got a…"
Stanley Pisarski replied to Stanley Pisarski's discussion 3dr 915 MHz radios Cannot receive any telemetry. Times out ..no heartbeat packets!"I have found the problem. It relies with the APM2 board. No matter what baud rate I set the APM2 for telemetry using the usb cable and mission planner even when I verify that the eeprom setting has been updated to the value and then when…"
Jake Stew replied to Stanley Pisarski's discussion 3dr 915 MHz radios Cannot receive any telemetry. Times out ..no heartbeat packets!"Check the serial communication between the two.
3DR really needs to put together a basic diagnostic guide. Seems like there's several posts a day from people having problems and wanting help, but haven't even checked if the…"
Stanley Pisarski posted a discussion3dr 915 MHz radios Cannot receive any telemetry. Times out ..no heartbeat packets!
I bought the 915MHz 3DR radios and I am having the same problem. The ground and air radios link together and I can run mission planner 1.0 with the the APM2 using the USB cable but when I disconnect the USB cable and connect the telemetry cable to the telemetry port and try to connect to the APM2 with the radio link through mission planner the countdown timer goes the whole way to o and times out with no heartbeat packet received. I have checked the serial port baud rate in APM2 and it…See More
Stanley Pisarski replied to Jakob M. L. Hansen's discussion 3dr + APM2"I bought the 915MHz 3DR radios and I am having the same problem. The ground and air radios link together and I can run mission planner 1.0 with the the APM2 using the USB cable but when I disconnect the USB cable and connect the telemetry…"
Profile Information
- About Me:
- Teach Electrical Engineering and fly rc electric airplanes
- Tell us a bit about your UAV interest
- Currently putting together the arducopter. Would like to do FPV flying with it in the near future.
- Hometown:
- Portage
Comment Wall
- No comments yet!
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
Moderators
24 members
-
Parlons français...
18 members
-
ArduCopter (traditional …
181 members
-
Canada
78 members
-
Agricultural UAVs
128 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
