I'm in the process of building an Octo and laying out the stack plates ready for them to be CNCd.Are there any rules on close proximity of radio transmitters, GPS receivers, XBee telemetry…Continue
I have two hard-drives on my system, drive C is a SSD for boot etc, drive D is the general installation drive. I then have a server with other networked drives etc for mass storage. When I install…Continue
Is there any one person who "looks after" the camera control / trigger side of things in the main ArduCopter code ? I have some Arduino based code that I have been working on for the following…Continue
I have been looking into my own method of mounting the APM with antivibration in mind.
To this end I wanted to source some freely available components specifically designed to reduce vibration.
I found a couple of such products which I am hoping will be ideal.
These coupled with a custom…Continue
I decided that my Drone looked a bit "naked" with all the electronics and flight controller exposed, so decided to have a dome made for it.
Made to measure and a perfect fit having been made from smoked acrylic so you still get to see those all important LEDs…Continue