"Thank you to Carmen and 3DR support team for posting firmware, and equally importantly, a .pdf with instructions on setting up the DIY drones version of the remzibi OSD board  (along with the differences between the DIY board and the original…"

"Patience prevails (thanks to Paul and his detailed blog http://www.happykillmore.com/Software/Faq.asp#2 )  The DIY remzibi OSD board only powers up when you provide the +12V and GND to (the 2 pins near the top of the image above).…"

"Hi there Rod.    You commented that you got the DIY rembzibi OSD to work.  I still get "Failed: OSD did not respond" error when I try <Start Test> in the Serial Cable Setup tab.   (I am using the DIY drones FTDI…"

"installed remzibi OSD on Vista x64.  Tried to do Serial Setup without success.  Used DIY drones FTDI cable to connect to DIY drones board (no other pins connected to anything), performed connect to COM23, then (per instructions) hold down…"

"After a bit more looking I answered my own question.  Thanks to Keith S for posting the info on Feb 28 at http://www.diydrones.com/forum/topics/remzibi-osd-3dr-1 Maybe 3D Robotics should include this info on the page where they sell the…"

"I have also purchased my Remzibi OSD 3DR, but I have not been able to find info about pin assignments and programming.  There is lots of info and documentation on the web about the original remzibiOSD, but the DIY drones board is quite…"

"I'm sorry I didn't read these posts more carefully before I spent >$110 w tax and shipping for this seemingly undocumented offering from 3D Robotics.   After spending most of the day trying to figure out the pin assignments and map…"