Tom Low
  • Male
  • Sebastopol, CA
  • United States
Share Twitter

Tom Low's Groups

 

Tom Low's Page

Latest Activity

Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"Thank you to Carmen and 3DR support team for posting firmware, and equally importantly, a .pdf with instructions on setting up the DIY drones version of the remzibi OSD board  (along with the differences between the DIY board and the original…"
Mar 23, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"Patience prevails (thanks to Paul and his detailed blog http://www.happykillmore.com/Software/Faq.asp#2 )  The DIY remzibi OSD board only powers up when you provide the +12V and GND to (the 2 pins near the top of the image above).…"
Mar 16, 2012
Tom Low left a comment for Rod
"Hi there Rod.    You commented that you got the DIY rembzibi OSD to work.  I still get "Failed: OSD did not respond" error when I try <Start Test> in the Serial Cable Setup tab.   (I am using the DIY drones FTDI…"
Mar 16, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"installed remzibi OSD on Vista x64.  Tried to do Serial Setup without success.  Used DIY drones FTDI cable to connect to DIY drones board (no other pins connected to anything), performed connect to COM23, then (per instructions) hold down…"
Mar 15, 2012
Tom Low replied to criro1999's discussion Remzibi OSD 3DR not working with Delorme GPS NMEA
"After a bit more looking I answered my own question.  Thanks to Keith S for posting the info on Feb 28 at http://www.diydrones.com/forum/topics/remzibi-osd-3dr-1 Maybe 3D Robotics should include this info on the page where they sell the…"
Mar 12, 2012
Tom Low replied to criro1999's discussion Remzibi OSD 3DR not working with Delorme GPS NMEA
"I have also purchased my Remzibi OSD 3DR, but I have not been able to find info about pin assignments and programming.  There is lots of info and documentation on the web about the original remzibiOSD, but the DIY drones board is quite…"
Mar 12, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"I'm sorry I didn't read these posts more carefully before I spent >$110 w tax and shipping for this seemingly undocumented offering from 3D Robotics.   After spending most of the day trying to figure out the pin assignments and map…"
Mar 11, 2012

Profile Information

About Me:
long time R/C enthusiast with an attraction to microprocessors, sensors, and other electronics
Please tell us a bit about your UAV interest
present interest is in autonomous landing of planes onto hard surface runway.

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Drone Delivery Challenge, is here

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service