"Fence loaded ok today after an inital FENCE_ACTION fail to set error.
Just a couple of things im seeing if anyone can confirm.
I'm using Mission Planner 188.8.131.52 build 1.1.5633.31488 Arduplane V3.2.1 (54ca5b2f)
When a fence is loaded but the…"
"Thanks Tridge but I believe the feeling here is that it would be handy if you could Disarm from the transmitter. Maybe if the sticks are set for a few seconds to the OBC Termination values. ie ailerons full left, throttle off, elevator full up,…"
No luck today at the field. Tried various permutations but always the same error when switching on the fence.
No I have tried loading the fence with MAVLink. Will give it a go and let you know."
"I don't see why replacing the concentric pitot tubes with some type of Venturi device wouldnt work.
It would cause a suction proportional to your speed. Just re plumb the pressure transducer to get a positive value."
The error occurs the moment the fence is switch on. The fence we use is one we have been using for the past 18 months. I have noticed from the screen shot you requested that we are in Disarm mode. I believe this error started around the…"
We seem to be getting a “geo-fence setup error” when turning on the fence since the last arduplane firmware upgrade.We have tried reloading and reading and creating new fences.Is anybody else seeing that?What are the conditions that trigger this error?APM2.5 V3.2.3MP 184.108.40.206 build 1.1.5593.22505WazSee More
"Yep, Tim it's exactly the same document. Smug rights are all yours.
And your right again. You would need an antenna of a gain greater than 10db to get yourself in trouble with the 3DR 915 at maximum output. That's another reason to get the…"
"Thanks Hotwire, that's a good document.
It's important to note that the maximum power stated refers to the Equivalent isotropically radiated power EIRP, that is transmitter power + antenna gain and not just the transmitter power.