Nathanael Xie Wenyao
  • Male
  • Singapore
  • Singapore
Share Twitter
  • Blog Posts
  • Discussions (2)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Nathanael Xie Wenyao's Discussions

Gibberish in CLI

Started this discussion. Last reply by Jason Short Jan 25, 2012. 4 Replies

Hi all,I'm hoping to get some help on this issue, since I've been battling it a long time now. My Arducopter is doing the flips on start up so I decided to go to CLI and try to check the motors etc,…Continue

 

Nathanael Xie Wenyao's Page

Latest Activity


Developer
Jason Short replied to Nathanael Xie Wenyao's discussion Gibberish in CLI
"that ss shows the wrong baud. 115k is the right setting. Try the three enters and this baud. Maybe you overlooked it. Jason"
Jan 25, 2012

JDrones
Jani Hirvinen replied to Nathanael Xie Wenyao's discussion Gibberish in CLI
"We had it on telemetry too but not sure if it's not activated as default due differences on APM1 and APM2. USB port works for guaranteed. So you might check that too."
Jan 25, 2012
Nathanael Xie Wenyao replied to Nathanael Xie Wenyao's discussion Gibberish in CLI
"Thanks Jani, The thing is I dont even see the first few lines. And if I hit enter or try to type anything at all, APM Planner freezes. The only way to quit then is to close the command prompt. Is CLI only meant to be used over the usb connection?…"
Jan 25, 2012

JDrones
Jani Hirvinen replied to Nathanael Xie Wenyao's discussion Gibberish in CLI
"It is not gibberish. For us humas it is but for ground station it is not. That feed is MAVLink data feed that starts immediately when you start your electronics.  Awhile back we made change on main program code and removed switch use…"
Jan 25, 2012
Nathanael Xie Wenyao posted a discussion

Gibberish in CLI

Hi all,I'm hoping to get some help on this issue, since I've been battling it a long time now. My Arducopter is doing the flips on start up so I decided to go to CLI and try to check the motors etc, however, all I get from the CLI after Opening COM Port is gibberish. I have attached a screenshot below.I do not think its a baud rate issue since I have tried using the serial monitor in Arduino IDE to read the port at all the different rates to no avail. Does anyone have any idea whats going on…See More
Jan 25, 2012
Nathanael Xie Wenyao posted a status
"ArduPilotOne Quadrotor Live Testing"
Dec 2, 2011

Profile Information

About Me:
ArduPilotOne Developer
Please tell us a bit about your UAV interest
Anything that flies...
or doesn't ;)

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2014   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service