Hi,Hopefully you can help me diagnose what I believe to be a failed ATMEGA32U2 chip on my APM 2.0 based on the following diagnosis.PC no longer makes a beep when connected via USB and extra COM port…Continue
"Well, 3dr got back to me and said my 32u2 or mux must have been damaged in the crash.
Is there a way to reflash teh 32u2 chip to try and get USB connectivity back? Is there way, other than the telemetry port of USB to talk to the thing?
"@ Dean - I've tried 3 different usb cables and 2 different computers to no avail. I did the "wiggle" the connector thing too, with no success.
@TFS - I looked it over very carefully under a magnifying glass. I found…"
"We had a similar problem. Completely unable to load firmware "error cannot detect APM version". Initially we thought it was a bootloaders problem
It turned out that a component (cannot remember which) had fallen off in shipping"
"I have found on my board the same symptoms and have put it down to loose connection of the mini usb cable, as sometimes it works and sometimes it doesnt, it requires moving around slightly until it connects and then dont even look at it or it…"
"I bought it from 3dr.
I just sent them an email yesterday asking about repairs, so I don't know yet.
I really want to see the logs. The esc's were beeping when I picked it up, so they weren't getting any signal from the…"
Hi,Hopefully you can help me diagnose what I believe to be a failed ATMEGA32U2 chip on my APM 2.0 based on the following diagnosis.PC no longer makes a beep when connected via USB and extra COM port is not found.RX and TX leds no longer flash on the boardReceiver inputs no longer control the servo's (PPM encoder not working ? i.e. 32U2 chip)Attempting to update the 32U2 firmware (thought it may have become corrupt) fails. PC still doesn’t see APM 2.0 following reset of 32U2 and hence unable to…See More