I do not think HDOP is displayed on the MP main screen. It would help to have it in OSD (via Mavlink) and on MP screen.
I let Randy comment on inertial position hold in lioter. Should that be preventing such fly…"
"Ok I think GPS (Loiter mode) makes my H4 approach ground at sub optimal angle and speed.
Happened on -rcX October 31 (rainy afternoon) and again today when filming icing.
Arducopter 3.1Stab mode and Alt Hold were just fine.The moment I switch…"
"Thanks Leonard, I see that default setting of ACRO_TRAINER 1 was holding me back. Felt almost like STAB mode. I am on 3.0.1 still, 3.1 since RC1 incorporated some changes to ACRO.
What would be recommended…"
"Is there a way to fly in ACRO mode with 60 deg pitch/roll limit removed? I would like to be able to do flips by pulling on the sticks. I am aware of the FLIP flight mode (toggle) which just does automatic flip.
Are we getting…"
"Oliver, I was flying close to "Around Georgian Bay". It looks like half of abnormalities are in Ontario where I fly! What is the source of this anomaly information? Can you please post a link?
"Environment screwed my FPV flight.
Before going up north to back country I looked declination of the place and programmed it with MP. It is different from where I usually fly... 400 km drive.
Some flight made over the river were with perfect…"
I truly do not know what would be a good place to land on GPS fail-safe during my last flight on Sunday with 3.0.rc5. In case of touch down copter recovery there would be close to impossible. So GPS FS is disabled!.
Now you guys…"
what motors, props and batteries you have on your Y6? I am flying Y6 as well. Mine built with 650 KV RCTimer 4215 motors, APC14x4.7 and 10000 3S and I get only about 6 minutes flights.
You definitely have props in the camera view.…"
I was flying 3.0-rc5. Switching from descend in ALT-HOLD or LOITER to STAB makes copter free fall immediately. Apparently full throttle does not save if from 40 meter altitude and I hit ground. That hurts. Any…"