giu
  • Male
  • Italy
Share

Giu's Friends

  • Horia Paun
  • Andrew Depalma
  • Bryce Fraser
  • Russell B. Sutton
  • CyberCrash
  • emile
  • Jean-Louis Naudin
  • Wojciech
  • Mark Colwell

giu's Groups

giu's Discussions

Near to give up

Started this discussion. Last reply by Björn Geir Leifsson Oct 19, 2011. 91 Replies

After many crashes, after short circuits and a new APM, after new propellers, after new motors, and after having spent money, I think that AC2 is quite difficult to setup.Here, it is a video of my…Continue

Xbee 868 simple range test fails

Started this discussion. Last reply by giu Jun 15, 2011. 4 Replies

I bought 2 Xbee 868 PRO. I know they have the duty cycle problem.But I just want to try a simple range test.I connected in loopback one one module (let call it A) and the other one (let call it B) is…Continue

Tags: test, range, xbee

 

giu's Page

Profile Information

About Me:
none
Please tell us a bit about your UAV interest
Make ad hoc networks

Giu's Blog

Fun with Naza

Posted on April 20, 2012 at 4:03am 2 Comments

I know that this is the place of diyers but I am trying to compare Ardu-based copter with other solutions. And by taking into account the conterless hours I spent with Arducopter I can say I am quite satisfied .

This is a video of a friend of mine.

Regards

 

MookaFrame: New 3D frame

Posted on December 2, 2011 at 3:25am 20 Comments

I am trying to convince me that AC2 can fly better...

So, in my spare time, I designed this new frame. I think to send in production (ponoko?) as soon as possible.

The concept is that everything, especially motors, must be protected.

I definitely must add the landing gear, propeller protection and camera mount, shouldn't I?

Any suggestion appreciated.…

Continue

[SOLVED] XBee 868 MHz two ways communication

Posted on June 15, 2011 at 3:30pm 9 Comments

One of the things not clearly said in the Wiki is that when you set Xbee communication, you MUST define correctly the addresses of the modules, otherwise you'll not get right communication.

After, 8 hours of chatting, writing post forum and headache, I noticed this fact when I tried a range test of Xbee by using X-CTU tool by Digi. One module was in loopback (just connect the DDI to DDO on the planeboard of the Xbee, and, obviously, connect the 5V), and the other one was connected to the… Continue

Configure 6 flight modes for Futaba T7CP

Posted on June 13, 2011 at 3:30am 29 Comments

I bought a cheap RC Futaba T7CP on ebay, but I spent 3 days in order to understand the right configurations of switches to enable 6 flight modes.

Here, my solution. Hope useful for the community.

(I used some hints from other blogs)



1. I used SWE and SWA. SWE is a 3-position switch. while SWA is on the left and it is a 2-position switch

2. You have to set End Point, SubTrim and RT in MIX. First, set the ENDPOINT for CH5 to be 50%(UP) and 52%(DOWN). You can tune…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service