"The setup looks correct to me.
It might be one of the bullet connectors is not soldered good and it has a bad connection. I had a similar problem when I wanted to calibrate my ESC's.
You can try to calibrate the ESC with a different motor…"
pienk's Discussions
PCB finish
Started Sep 18, 2012 0 Replies 0 Likes
H,I I just received my Arducopter kit and am busy putting it together.I was wondering about the PCB finish. Is it silver or HAL?I it is silver I am thinking about coating the unused holes with some…Continue
pienk's Page
Latest Activity
pienk replied to Raimondo's discussion Quadcopter - First flight - Assistance for take-off please!"Looking at the picture, and comparing my quad, I think your props are on the wrong motor.
If you are using the APM board you can check the wiki here for the correct prop setup and motor turning direction.
Hope this helps.
Rienk."
pienk posted a discussionPCB finish
H,I I just received my Arducopter kit and am busy putting it together.I was wondering about the PCB finish. Is it silver or HAL?I it is silver I am thinking about coating the unused holes with some solder to protect the board form corrosion.RienkSee More
Profile Information
- Tell us a bit about your UAV interest
- thinking of building one
Comment Wall
- No comments yet!
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
Moderators
24 members
-
Andropilot Users Group
203 members
-
ArduCopter User Group
1355 members
-
ArduRover User Group
207 members
-
Japan ArduCopter Group
58 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
