Hi All, This forum has been so helpful so I thought I would give back and contribute...

I was trying to understand how a previous poster on this forum actually did the 6 Position 2 Pole Rotary Switch Mod with LED Feedback. No where is there a write up on the HOW-TO for the LEDs but…

Episode 6

Drone Cafe Video Podcast…

Well, technology is developing fast, but one issue always remains: how to config the TX to allow 6 modes...

Here is a 6 modes switch for ANY Transmitter !

Enter for details

The idea is to have 4 trimmers to allow precise setting of the wanted PWM…

These instructions explain how to set up a Spektrum DX7 transmitter for 6 different flight modes, using just the 3 position Flaps switch (in combination with the Rudder switch). This way you'll use just one channel for the flight modes and leave the Gear and Aux2 channel open ...

(note that you have to use…

The T6EX doesn't have a 3 position switch channel, so I had to combine channel 5 and 6 to get four modes. I made it work with a pot that has double terminals for each knob position, so that way there is always 2 pins to connect cables to for a single position.

Think of this knob as a bridge between same terminals: A to A, B to B, etc, closing the circuit to ground.

Channel 6 is connected to a terminal A and a terminal B from the opposite side.

Channel 5 is…