Here are some Photos showing how to get 6 positions on a Futaba 9C super

It will set them for these 2 switches

go to advanced settings choose PMX-6 CRV…

Continue

Just got some recording software for FPV figured out and I figured I'd post a video of me and some friends flying the Bixler in a park. The conditions were pretty windy so there wasn't any fancy flying, but still some nice views :). The battery dies so the motor cuts off at the end of the flight. The sound was coming from my laptop's mic not the mic on the plane so…

Continue

The T6EX doesn't have a 3 position switch channel, so I had to combine channel 5 and 6 to get four modes. I made it work with a pot that has double terminals for each knob position, so that way there is always 2 pins to connect cables to for a single position.

 

Think of this knob as a bridge between same terminals: A to A, B to B, etc, closing the circuit to ground.

Channel 6 is connected to a terminal A and a terminal B from the opposite side.

Channel 5 is…

Continue

The R617FS receiver is for the 2.4GHz Futaba 6EX transmitter and so "requires" a 90° position to function. So with the elevator channel being used for elevons (in the wings) the servo hole on the side of the chassis is redundant, that hole shall take my receiver. After… Continue