Ellison Chan's Blog Posts Tagged 'multirotor' (1)

First Flight of 3D Printed Firefly Mark One Quadcopter Frame

Firefly Mark One Flies in TREX Configuration. It's like a Space Odyssey!

As you can see above the 3D printed frame project has advanced one more step. I have fitted the 3D printed hub with 4 cut down TREX 450 (12mm) tail booms. It's being flow in Stability Mode. Just a note on cutting the…

Continue

Added by Ellison Chan on January 23, 2012 at 5:28pm — 6 Comments

Latest Blog Posts

First Flight of 3D Printed Firefly Mark One Quadcopter Frame

Monthly Archives

2013

February (1)
January (1)

2012

November (1)
January (3)

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	ArduCopter-3.0 ready for wider use
2	APM Project vs DJI NAZA and WOOKONG
3	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
4	APM Copter 2.9.1.b has been released
5	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	MAAT final version is being tested
8	Getting ready for Arducopter 3.0
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	How to succeed without really trying

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.