Hi gang :)))

Time to update blog. Story, named "Primus III". Prewiously, I show fuse building process:

Give me a fulcrum...

I'll go sleep now, because of my injury is less.…

and I'll take any twist. :)))

Remember me? I'm still here!

Began sheeting Primus III fuse...…

Week end. Friday.

Primus fuse remove from building slip.

Looking small, but still have over 2 meters. :)…

Where I've already seen...

A long time ago...

When computers were large...

I build a plane, called the Primus. But this was not the first Primus, first gone forever.…

Uff...All dirty jobs are done. Trial fit, nearly 9 meters.

Now - clean, sand, spackle, prepear for…

Some time we need to work with metal parts. For example - motor mount.

Is a vibrationless motormount for MVVS 152 cc twin spark engine. I think it's possible made from wood, but aluminium look much better for me.

Photos only...More about progress in build later.…

Friday... This week progress. Only photos, any comments.…

Monday - day heavy, as you know. So long as any work starts on Monday. So I have - apart from today started…

First, load the fuselage to an inability to move. And…

Friday morning

Friday evening...…

Testing a wing joiners. :)

New challenge.

Abowe - outer wing part. Below  - inner.

Half wing span - 4,5 meter.

After years of experiments...No more tailless design.

In the last few days I make some test fly for short distance.

On ground station we use YAGI 16 dBi antenna without tracking system, connected to XBee modem with 5 meter cable.

For distance ~2,5 km system work very fine...

 Mamadu take a new fin for better yaw stability.…

This project has been started in october 2009  and its purpose is to build a full autonomous short range reconnaissance survey plane.

Currently Mamadu UAV used Paparazzy YAPA v.2 board, CHIMU IMU, Xbee modems for telemetry downlink and VTQ video equipment.

  …