After the crash on yesterday I again rebuild the frame using new 12mm aluminium square pipe with same length of 14inch or 355mm with 10x4.7 props. Built the frame and mounted the motors and electronics. Reloaded the software with 4.5 + reboard firmware.
During the test it seems to be good. Trying to achieve a hover vehicle by adjusting the EPA and trims. Most of the the part did work well. But as soon as I finished testing I switched off the Tx thinking that I unarmed the…Continue
Hi, I've made a Quad X copter using KK Multicopter blue board v4.5 (ofcourse I waited for 15 days to receive the board after placing the order). But mine is not going up. Its rotating on the ground. I don't what the problem is.... I've tried and tweaked as much as I can do by referring many sites. Also build 4 frames. But in vain. Its been two weeks I'm trying to make it fly.
1450kv outrunner brushless motors
12A BEC Esc
3S 25C 2500mAh 11.1v…Continue