Comment by Vincent Mees on April 23, 2012 at 11:37am

Very nice.

Do you have moreinfo on the AP board?

Comment by Vincent Mees on April 23, 2012 at 12:38pm

found it ;-)

http://diydrones.ning.com/profiles/blogs/xmega-ap-and-esc

Comment by George P. on April 23, 2012 at 2:08pm

In general, it is recommenent to place the ESC's as close as possible to the motors.

Otherwise too much electric noise may radiated and interference with other sensitive electronics.

Comment by Crispin on April 23, 2012 at 3:31pm

That looks neat. the 3DR ones look like they vomited thier intestines. I'm trying to make mine look neat :(

Comment by Sergiu on April 24, 2012 at 12:41am

@George P. - If you twist all cables (plus with minus,motor cables), lot of EMI will be canceled;however 2-3 deg error will be in compass when motors are spinning but can be removed in software.

@Crispin - Thank you.

Distributor Comment by UnmannedTechShop.co.uk on April 24, 2012 at 1:54am

Very nice, and neat install.  It almost looks like the electronics are missing from your Hexa when you put attach the top plate.

Comment