Hi Guys It has been a while .My plane is probably 1/2 built I has been "modified and is now a EDF. I covered one of the wings with ultra cote I have to re iron it a couple of more times to get it smooth You think you got it leave it for a while come back and you find spots you missed I started covering the ailerons and flaps also. Then I have to put on the hinges and rigging to the servos in the center of the wing . I found out just recently the word Lypo and Lead start with the same letter and are not much off as far as weight goes ! In the picture of the batteries on your left is the 6s 22.2v 5000mah 30 c lipo that weighs as much as the plane beside it the little green thing is the lipo out of my radian pro to give it some scale and on your right is the 100amp phoenix ice ESC by castle They are going to be suspended in front of the EDF for cooling. The fuselage still weighs under a pound I added air scoops on each side and drilled many more holes to take the added weight back off . The EDF is mounted on "U" shaped nylon rails I have to make a thrust tube behind the EDF and re cut the foam I already made for the fuselage I am going to cover the Exoskeleton and fuselage foam with Rip stop nylon Sail repair tape. I have to build a elevator and I am going to laminate a over sized partially balanced rudder . I might make it a tail dagger
with "Tundra tires" ( I still have the landing gear out of the "Somthin Extra and a 26 cc gas engine if this doesn't work) also is a picture of one of the full size metal gear servos for the rudder and elevator at the back of the plane. You guys have a good day!