3D Robotics Comment by Chris Anderson on October 4, 2010 at 11:18pm

+1 on John Church's suggestion. I'd buy a few hundred to sell in the DIY Drones store!

Comment by Taylor Cox on October 4, 2010 at 11:21pm

@Peter, how much did it cost you to build your Laser cutter?

Comment by Peter Koppendorfer on October 4, 2010 at 11:38pm

Hello,

The cost for the Lasercutter = 5000 Euros

Moderator Comment by Gary Mortimer on October 5, 2010 at 12:25am

Nice idea Peter well done

JDrones Comment by Jani Hirvinen on October 5, 2010 at 3:05am

Great looking box. Tho Peter I would suggest to use either plastic or stainless screws. One your screws is really close to your magneto and it might affect your magneto readings. Also you should check if barometer is affected.

Developer Comment by Mark Colwell on October 5, 2010 at 5:32am

Can your laser cut 1.5 mm G4 glass fiber board?

Comment by Peter Koppendorfer on October 5, 2010 at 6:48am

Hello Mark,

No sorry ! the Glasfiber in the board is like a optik it burn the Epoxi !

Comment by Tom on October 5, 2010 at 7:17am

OK where or when will i be able to buy them i think that a great idea Tom

Comment by Dan Smithson on October 5, 2010 at 8:42am

Hi,

I would be interested in one.. if you start a small production.

Comment by Peter Koppendorfer on October 5, 2010 at 8:49am

Hi,

I will send some to Chris and he will make it in the DIY shop !!

in Europa i can send it from here

Regards
Peter

Comment

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page