Gender
Male
About
Location
negeri sembilan
About Me:
Im an aerospace student and amateur RC builder.
Please tell us a bit about your UAV interest
i want create UAV that is very useful and can perform various task.
Hometown:
kuala klawang
Activity Feed
hye!im doing some modification in arducopter 3.0.1 sourcecode. im trying to modify its velocity profile. so i need to clarify what does this mean.'// calculate the horizontal error','// calculate the vertical error',' // calculate how far along the…
"hye there!just to be sure. is it normal when the board connected by usb the, the alive will light.and when connected the C and A will blink.am i right?and one thing if let say i upload the arduplane firmware,can i also upload arducopter firmware to…"
"hye!can someone tell me what things should i know to programme this ardupilot board?i really interested in this matter. any helps i will really appreciate it.Thank you! regards"
"assalamualaikum!thanks for adding me as your friend. im too an APM beginner. so hope we help each other. "
"just want to be sure.im a beginner so i really2 need guide in this thing. hope you dont mind helping me.thanks alot k. "
"hye!@ Thomas J Coyle III is it ok if i connect the usb cable to the ardupilot board with jumper jp1 connected and without power module cable and gps module?"
"hye!can some one guide me how to setting up ardupilot v2.6?i have issue here because should i connect the jumper to the board? because i want to power it using USB cable."
"waw!you freak me out!i just bought it yesterday and not yet connect it."
"hye!im new here!and im new in multirotor.im using the hexacopter and hope we can share alot of information here!thank you!"
"hye!could anyone help me how to make the hex reroute again after it receive new GPS coordinate during it is flying following the predetermine coordinates.example is, let say you been given 5 gps coordinate, 1, 2 ,3, 4, 5.when the hex fly when it…"
"Try to launch at 60% or cruise throttle, if it dives lift the rear of the motor higher than the front of the motor, if that does not help then your horizontal tail is too small,
RSS
thus this also i need to deflect my elevator a bit during…"
RSS
thus this also i need to deflect my elevator a bit during…"
hye! i need some help!please!my rc is pusher configuration. do i need to shift my cg backwards so that it will become tailheavy. the reason is, thrust generated by the motor will counter the the tail heavyness. before this, i have design one. during…
"thank you all!i really appreciate it!"
hye!can anyone tell me how i can control my rc using samsung cellphone?can anyone know what should i do?
